How to Install
The instructions below are only to install the dishwasher drip pan, not the appliance.
1.  After dishwasher is pulled out, examine and inspect  
floor for defects.  The dishwasher opening must have a  
floor the same level as the flooring
directly in front of
where the dishwasher sits
, allowing any water to flow out
in front of dishwasher.
2.  The pan is then placed in the opening approximately
1" back from the cabinet "toe-kick" line.  (The "toe-kick" is
the front of the cabinet base.)
1.
2.
Dishwasher DiaperTM by HINES APPLIANCE PRODUCTS
3.  Place a strip of masking tape along front edge of
pan
.  This marks where the pan sits and will also
collect the excess sealant.
6.  Secure the front of the pan to the floor using
screws provided.  Remove masking tape and excess
sealant
.
7.  Apply the plastic tape to the front edge of the
pan protruding 3/8" on to the floor.  Next, apply
side flashings as shown in picture.  
Note: For tile or
stone floors, use the plastic tape instead of screws to
hold pan in place.
5.  Place the drip pan back into position, aligning
the front edge
with the masking tape.  Press down
along front edge, squeezing the sealant evenly and
up through the screw holes
.
4.  Lift and support the front edge of the pan and
apply 1/4" size bead of clear silicone sealant
(included with kit) approximately 3/4" behind the
tape
.  Also, apply sealant generously to the sides of
the cabinet.  This sealant is needed in order to
prevent water from a leak and from seeping under
the pan after it leaves the pan.
4.
3.
5.
6.
7.